Note layout dialog

From MusiCAD
(Redirected from Layout)

The note layout dialog makes it easy to format your scores any way you feel fit.

Layout dialog

Scaling horizontal
Scaling vertical
Horizontal and vertical scaling allows for bigger/smaller notes and thus determine the note-density of a page and line. 100% is a usable default. Most of the time horizontal and vertical scaling will get the same value.
Min note-distance
Minimum note distance determines the minimum spacing between notes on a line. 100% is the default at which the shortest notes are one unit apart.
Max note-distance
Maximum note distance determines the maximum spacing of notes on a line. 100% is the default at which the longest notes are 4 units apart.
Bars/line
Fixate the desired number of bars per line. Note that an upbar will not be counted. Explicit line breaks will accommodate for earlier breaks, and changing the bar number on hard bar lines can add an extra bar. 0 allows MusiCAD to fit as much as possible bars on a line (default).
Line-fillpercent
Any line that is not filled for at least the percentage supplied here be right-justified. If set to 100% a ragged right margin will be the result. Conditional line-breaks in the rest of the line will render effective, within the percentage they will not.
Staff height
Fixed height of a staff in vertical units. Setting staff-height to 0 will call for automatic staff-height.
Line distance
Minimum distance between two lines in vertical units
Staff distance
Minimum distance between two staffs in a score in vertical units.
Lines/Page
Fixate the number of lines per page. 0 allows MusiCAD to fit as much as possible lines on a page (default).
Page-fillpercent
At any page break MusiCAD may distribute the remaining vertical whitespace over the existing lines of a page. Within the page-area outside percentage supplied any conditional page-break will render effective.
Header height
Fixate the header height to the number of vertical units which may be 0 for calculation by MusiCAD (default).
Header distance
Extra whitespace after the header
Nexthdr height
Fixed height of the headers on other pages than the first. 0 for automatic calculation (default).
Footer height
Fixed height of footers. 0 for automatic calculation (default).
Section height
Height of new sections.
Indentation 1st
Indentation other
Indentation whitespace at the beginning of the first, resp. other lines.
White before bar line
White after bar line
White after key
You can instruct MusiCAD to add extra whitespace before and after bar lines and keys. In most cases modification will not be necessary. (default 0)
Fill orphan lines
Any lines terminated manually, as well as the last line of the score might have less notes than the other lines. To enhance the layout MusiCAD can spread notes of these 'orphan' lines the same way as average lines.
Minimum tie distance
Ties and slurs are drawn differently if notes are spaced widely. Ties between close-spaced notes will be drawn like slurs if the distance between notes is smaller then the value supplied (in 1/100 of horizontal units)
Display tempo as text
Tempi may be displayed as text (like allegro) or using beats per minute
Truncate staff lines
Not-justified staff lines may be drawn as blank (truncated) of just as empty staff (default is truncated)
Hide grace notes
To print 'easier' parts you may suppress the grace notes (default off)
Stem length
Note-stems are usually drawn such that any single note will have a length of 7 vertical units, one unit less the the height of one 5-line staff. If you need smaller or larger stems this is the place to request your needs.
Ledger line width
Ledger-lines (the extra lines drawn outside the staff when drawing very high or low notes) should not be too wide or too small. If you'd like to have them wider enlarge the percentage.
Staff line weight
Stem line weight
Bar line weight
You may accommodate (enlarge) weight values if your eye-sight is decreasing or when you need to scan music-paper.


Retrieved from "http://en.musicad.eu/w/index.php?title=Note_layout_dialog&oldid=3594"